![]() 31 addresses are also all host IDs with no reserved 0th address.Įasiest thing is web search and read articles related to subnet mask and subnet mask binary shorthand and CIDR In the case of /32, this doesn't apply as the address is both a network ID and host ID. A /16 IPv4 network has a subnet mask of 1111.1111.0000.0000, meaning the first 2 octets are the network ID and the last octet is used for assigning host IDs (65536 available IDs, though usually some are reserved).A /24 IPv4 network has a subnet mask of 1111.1111.1111.0000, meaning the first 3 octets are the network ID and the last octet is used for assigning host IDs (256 available IDs, though usually some are reserved).The network ID portion of an IP address is determined by the subnet mask. For example, this may be used for decommissioning a system. This only allows traffic to destinations defined explicitly by static routes on the system. A network security gimmick: isolate the machine with the /32 netmask from the rest of the systems on the subnet.A webserver serving multiple sites with each site bound to a specific IPv4 address.There are a couple of possible reasons for this that I've seen. The device would not be able to communicate with other devices on the local subnet. ![]() Generally speaking, /32 means that the network has only a single IPv4 address and all traffic will go directly between the device with that IPv4 address and the default gateway. So what you're seeing in the route listing is a mix of actual network routes (like the "default" and 192.168.1 entries), and per-host entries (the /32 and MAC-targeted entries). The "openwrt.lan" entry above (which I'm pretty sure is actually 192.168.1.1, just listed by name rather than number) says that it's routed via en0 to the MAC address 46:94:fc:63:fc:7. I don't know why macOS creates these redundant address-specific entries, but it's probably related to another thing you can see in the listing above: macOS lists its ARP table entries in the routing table. If you compare those /32 entries with the 192.168.1 entry, they're basically redundant duplicates they say the same thing, just about specific addresses instead of the entire network range. ![]() 192.168.1.1 and 192.168.1.125 are both specific addresses within that network range. This is the network that the Mac itself is on. Note that 192.168.1 (short for 192.168.1.0/24) is routed over en0 (aka link#4) not via any gateway, just over the interface itself. Let me add some lines before the ones you quoted: Destination Gateway Flags Refs Use Netif Expire Usually the two are the same (because you route a network or subnet as a unit, right?), but macOS does things a little different for other hosts on the same local network. There's a bit of confusion here that /32 doesn't refer to the size of any (sub)network, but to the range of addresses that particular routing table entry applies to. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |